This paper reviews the energy yield enhancement characteristics of bifacial photovoltaic systems combined with solar tracking, focusing on their performance relative to conventional monofacial fixed-tilt configurations. The fundamental mechanisms of yield improvement are summarized, highlighting the largely additive contributions of solar tracking, which increases front-side irradiance, and bifacial modules, which utilize rear-side reflected and diffuse radiation. Reported results from previous studies indicate that bifacial systems with single-axis tracking typically achieve 25–35% higher annual energy yield compared with standard monofacial fixed-tilt systems, with variations depending on environmental and design conditions. Key design and environmental considerations influencing system performance are discussed to provide practical insights for the application of bifacial tracking systems in utilityscale photovoltaic installations.

To ensure the long-term reliability of flexible photovoltaic (FPV) modules, it is crucial to develop an effective moisture barrier layer that prevents the infiltration of moisture and oxygen. We developed such a layer composed of parylene (700 nm) and AlOx (70 nm), optimizing its material properties, moisture-blocking performance, and processing conditions. The barrier layer applied to the Ethylene Tetrafluoroethylene (ETFE) substrate demonstrated a water vapor transmission rate (WVTR) of 6.33 × 10^-2 g/m²/day and an average visible light transmittance (AVT) of 85.3% over the 380-780 nm wavelength range. For the FPV module with this barrier, Damp/Heat (DH) reliability testing was conducted at 85℃ and 85% relative humidity for up to 1,000 hours. During testing, the power conversion efficiency (PCE) decreased slightly from 25.4% (0 hr) to 24.7% (1,000 hr), reflecting a minimal reduction of only 0.7%. The primary cause of degradation was identified as a -4% relative change in shortcircuit current density (JSC) before and after DH testing. Consequently, the ETFE/parylene/AlOx multilayer moisture barrier proved highly effective in ensuring the long-term reliability of solar modules.

Recently, with the increase in the use of urban solar power, solar modules are required to produce high power in limited areas. In this report, we proposed the fabrication of a high-power photovoltaic module using shingles technology, and developed accurate string characteristic simulations based on circuit modeling. By comparing the resistance components between the interconnected cells and the cell strips, the ECA resistance was determined to be 0.003 Ω. Based on the equivalent circuit of the modeled shingled string, string simulation was performed according to the type of cell strip. As a result, it was determined that the cell efficiency of the 4-cell strip was the highest at 19.66%, but the efficiency of the string simulated with the 6-cell strip was the highest at 20.48% in the string unit.