The improvement of irradiation intensity and irradiation uniformity is essential for large area and high power UVA light source application. In this study, large number of chips bonded by micro soldering technique were driven by low current, and current limiting diodes were configured to supply constant current to parallel circuits consisting of large number of series strings. The dimension of light source module circuit board was 350 × 90 mm2 and 16,650 numbers of 385 nm flip chip LEDs were used with a configuration of 90 parallel and 185 series strings. The space between LEDs in parallel and series strings were maintained at 1.9 mm and 1.0 mm distance, respectively. The size of the flip chip was 750 × 750 μm2 were used with contact pads of 260 × 669 μm2 size, and SAC (96.5 Sn/3.0 Ag/0.5 Cu) solder was used for flip chip bonding. The fabricated light source module with 7.5 m A supply current showed temperature rise of 66℃, whereas irradiation was measured to be 300 mW/cm2. Inaddition, 0.23% variation of the constant current in each series string was demonstrated.

Modified structure of copper pillar bump which has trapezoidal cross section on the top region is suggested with simulation results and concept of fabrication process. Due to the large surface area of joint region between bump and solder in suggested structure, electro-migration effect can be reduced. Reduction of electro-migration is related with current density and joule heating in bump and investigated with finite element methods with variation of dimensional parameters. Mechanical characteristics are also investigated with comparing modified copper pillar bump and conventional copper pillar bump.